#statusMessage#
Do you want to start the comparison now?
#statusMessage#
Do you want to start the comparison now?
Without reliable communication, safe operation is impossible. In the aerospace industry, failures are not an option. At ...
In safety-critical development and manufacturing processes, the test architecture determines quality, cost efficiency, a...
Increasing efficiency requirements in vehicles, data centers, and industry are driving new vehicle electrical system and...
Early prevention, comprehensive certification, targeted troubleshooting. In every area of your data center, measuring in...
Manufacturer number: PP0002A
| Article number: | PP0002A |
|---|---|
| Electrical safety: | CAT II |
| Input impedance: | 40 MΩ |
| Model: | PP0002A |
| Weight (kg): | 0.2 |
| max. Frequency range (MHz): | 800 |
Note: The adapter PP0004A is required to use the probe with the Autoprobe I interface.
The Hi-Z + Probe PP0002A is a passive high voltage probe (HV Probe) with an analog bandwidth of 800 MHz and a capacitive load of less than 2 pF, while delivering an unprecedented input voltage of 1200 Vrms . It offers all the advantages of a passive probe head with the performance that is normally known from an active probe head. The AutoProbe I interface offers offset and auto configuration of probe type and damping setting.
The PP0002A is intended for use on InfiniiVision and Infiniium oscilloscopes with the AutoProbe I interface using the PP0004A adapter .
The probes PP0001A / 2A / 3A are a new generation of Hi-Z + probes in which the probe can be seen as a combination of probe and probe adapter (PP0004A). This combination does not have a fixed damping ratio, but rather several available damping ratios per given V / div setting in order to enable a very large dynamic range and a flat frequency response.