FLIR CM82 | True RMS Multimeter (Clamp Meter with Integrated Multimeter) for 600 A, with traceable NIST calibration certificate.
Industrial grade clamp meter with extensive current analysis functions and filtering for inverter controlled drives.
The industry-standard FLIR CM82 clamp meter is specially designed for complex fault diagnosis with high-quality current analysis functions. These include harmonic mode to detect noise from various electrical sources, rotating field mode to check the phase sequence of three-phase systems for easier diagnostics in motors and installations, and start-up current mode to detect power-on transients. The FLIR CM82 is also equipped with inverter-controlled drive filtering to analyze non-sinusoidal waveforms and noisy signals in variable-speed drives. This simplifies the localization of electrical problems in complex industrial and commercial systems.
Equipment and highlights:
- In VFD mode, the variable signal frequency is conditioned by filters and the exact frequency and voltage values are measured. This is important in service and repair work.
- Analog bar graph of measured values
- Power and power factor measurement
- True RMS Measurements of alternating and alternating DC voltages
- Large, easy-to-read display, 10,000 counts
- An additional illumination by a bright white LED in the display ensures good reading even in dark rooms
- Automatic AC / DC detection even at maximum current of 600 A
- Automatic AC / DC detection even at maximum voltage of 1000V
- Automatic resistance, continuity and diode test detection
- Measurement of harmonic content / distortion up to the 25th order
- Indication of the phase rotation
- Resistance measurement up to 100 kΩ
- frequency measurement
- capacitance measurement
- Hold the last measurement
- Peak measurement and storage
- Measurement of inrush currents
- Zeroing for DC currents
- Storage of maximum, minimum and average value
- VFD mode - low pass filter
- Detector for detection and display if there is no contact
- Automatic switch off of the device when not in use
- Pliers opening: 37 mm for 31 mm cable
- Withstands a drop of 1.2 m
- Safety category: CAT IV-600V, CAT III-1000V
- Overvoltage Category: IEC 61010-1 CAT IV-600V, CAT III-1000V, IEC 61010-2-033.
- Specified temperature range from 18 ° C to 28 ° C with specified accuracy: 0.2 * (Accuracy) / ° C
- Dimensions: (H × W × L): 49 mm × 100 mm × 262 mm
- Weight 590 g with batteries
Delivery:
- 6 AAA batteries
- Manual / CD
- CAT IV silicone test cable
- Limited Lifetime Warranty
- With traceable NIST calibration certificate